Electrodepot  
 
   PERFORMANCE

• 5 Miles ( 8 km ) line of sight, 
• 2000 feet (600m) inside partially obstructed
 • Optional extended range 20 Miles ( 32 km ) line of sight

Transmitter and Receiver Enclosure:

 Aluminum Die Cast Hinged Enclosure
and U-Bolt Pole Mounting Hardware
Weatherproof specification: IP67

Applications:
Pump controls, lighting control, tank level, irrigation, well pump, process, packing, gates, traffic, automation, farm management, perimeter monitoring, security
 SPECIFICATIONS
Voltage: 12 to 15. VDC
Temperature: -4° to +140° F (-20° to +60° C)
 Receiver :  Digital 16bit -118 dB 
 Frequency  27,255 MHz
 Codes:  65,536 DIP switch programming
Current Drain Receiver  25 mA, standby, 195 mA operation
Transmitter 1 mA standby, 2 Amp 7 sec.
Data process  Encoded Loop response 500 ms.
Relay Output 10 Amp max 30VDC -  250VAC N/0 and N/C
Antenna  50 Ohms Quarter Wave, Antenna optional
Dimensions: 24.13 x 19.05 x 8.89 cm / 9.5  x 7.5 x 3.5 inch
Weight 6 lb. (3 Kg) each
Enclosure NEMA 3X   metallic
7500 Timed Single Channel     
 7500  Transmitter & Receiver Kit

 1  Base Transmitter dry contact input  part# 937211
    or one Portable transmitter part# 937311
 1  Base Receiver pre-wired,  With controller- timer
 2  Antennas, 21" omni

   OPERATION: Momentary, Toggle or Time
  
9001 Supervised Single Channel  
 9001  Transmitter & Receiver Kit

 1  Transmitter set  dry contact input, and control module
 1  Base Receiver set  with control module
 2  Antennas, 21" omni
 2  NEMA 3X metal enclosure
 2  Power adapters 12VDC
 1  Wiring Diagram
 
  OPERATION:
Pre programmer panel for single float circuit application,
On (Low) Start contact closes, the transmitter sends a pulses every 5 minutes for verification
On (High) Stop contact opens, the transmitter sends a pulse to stop the operation.
If the pulse is not received in the range of the time interval the system turns off.
 
9004 Controller 3 Channel  with overflow  

  9004  Transmitter & Receiver Kit

 1  Transmitter set  dry contact input, and control module
 1  Base Receiver set  with control module
 2  Antennas, 21" omni
 2  NEMA 3X metal enclosure
 2  Power adapters 12VDC
 1  Wiring Diagram

  OPERATION:
Pre programmer panel for a three float circuit application,
On contact closure (Low) sends a pulse to start the pump
On contact closure (High) sends a pulse to stop the pump
With (Overflow ) second  stop signal  to end the operation



DISCLAIMER:  Contact a licensed professional for your project.